Abstract
Protective devices disconnect the supply when a hazard is detected but do not indicate whether an anomaly originates in the fixed premises wiring, the connected equipment or the interface between them. This paper formulates source attribution as selective classification with a reject option and studies a continuous-power radiofrequency (RF) boundary: a device that keeps an unswitched power path in circuit while a separate RF path is switched between through and shadow states. A two-port analysis shows that the isolation of such a boundary is limited by the power path and terminations rather than by the switch, and yields a criterion for selecting the diagnostic band. In an unpowered bench characterisation, a boundary with a 47 μH power path permanently connected changed the house-to-load transmission by −22.5 dB over 190–300 MHz, repeatably to 0.021 dB and within 0.55 dB of a model built from separately measured components. Two blinded trials on a 25 m line analogue with resistive series substitutes followed. In the first, every wiring-side substitute was attributed to the fixed wiring, and thresholds were shown to require baselines that capture handling variability; the second trial showed that loadside attribution requires a redesigned load-side observation point. Across both trials, the wiring-side substitute was completely separated from the other conditions on the house-end residual (8 versus 15 trials; AUC = 1.0; post hoc) and appeared as a time-domain peak close to the house-end reference plane. The results establish the bench basis of the method and define its extension to two-sided attribution.
Keywords
Electrical fault diagnosis, fault attribution, reflectometry, time-domain reflectometry, S-parameters, vector network analysis, RF switching, selective classification, reject option, blinded evaluation, measurement uncertainty.
References
[1] General Requirements for Arc Fault Detection Devices, BS EN 62606:2013, British Standards Institution,
2013.
[2] Requirements for Electrical Installations. IET Wiring Regulations, BS 7671:2018+A2:2022, Institution of
Engineering and Technology and British Standards Institution, 2022.
[3] D. M. Pozar, Microwave Engineering, 4th ed. Hoboken, NJ, USA: Wiley, 2012.
[4] C. Furse, Y. C. Chung, C. Lo, and P. Pendayala, “A critical comparison of reflectometry methods for location
of wiring faults,” Smart Struct. Syst., vol. 2, no. 1, pp. 25–46, 2006.
[5] P. Smith, C. Furse, and J. Gunther, “Analysis of spread spectrum time domain reflectometry for wire fault
location,” IEEE Sensors J., vol. 5, no. 6, pp. 1469–1478, Dec. 2005.
[6] M. Zimmermann and K. Dostert, “A multipath model for the powerline channel,” IEEE Trans. Commun.,
vol. 50, no. 4, pp. 553–559, Apr. 2002.
[7] M. Sapir, “Apparatus for the detection and early warning of electrical arcing fault,” U.S. Patent 6 667 691 B2,
Dec. 23, 2003.
[8] J. Eriksen et al., “Electrical receptacles, assemblies thereof, and end of life functionality,” U.S. Patent Appl.
2024/0332946 A1, Oct. 3, 2024.
[9] R. E. Teggatz et al., “Electrical interconnect status monitoring system,” U.S. Patent 9 599 660 B2, Mar. 21,
2017.
[10] A. G. Sappok et al., “Radio frequency process sensing, control, and diagnostics network and system,” U.S.
Patent 10 799 826 B2, Oct. 13, 2020.
[11] L. Liao, Z. Liu, J. Du, and L. Hai, “A fault diagnosis method for pole-mounted circuit breakers based on
multi-information fusion,” CN Patent 121389025 B, Apr. 10, 2026 (assignee: Nanjing Ludian Intelligent
Technology Co., Ltd.).
[12] B. Maxson and W. Miller, “Ingress noise localization in a cable network,” U.S. Patent 8 724 681 B2, May 13,
2014.
[13] C. K. Chow, “On optimum recognition error and reject tradeoff,” IEEE Trans. Inf. Theory, vol. IT-16, no. 1,
pp. 41–46, Jan. 1970.
[14] Y. Geifman and R. El-Yaniv, “Selective classification for deep neural networks,” in Proc. Adv. Neural Inf.
Process. Syst. 30 (NIPS), 2017, pp. 4878–4887.
[15] JCGM, Evaluation of Measurement Data—Guide to the Expression of Uncertainty in Measurement, JCGM
100:2008, 2008.
[16] C. J. Clopper and E. S. Pearson, “The use of confidence or fiducial limits illustrated in the case of the
binomial,” Biometrika, vol. 26, no. 4, pp. 404–413, 1934.
[17] H. B. Mann and D. R. Whitney, “On a test of whether one of two random variables is stochastically larger
than the other,” Ann. Math. Statist., vol. 18, no. 1, pp. 50–60, 1947.
[18] J. Cohen, Statistical Power Analysis for the Behavioral Sciences, 2nd ed. Hillsdale, NJ, USA: Lawrence
Erlbaum, 1988.
[19] B. A. Nosek, C. R. Ebersole, A. C. DeHaven, and D. T. Mellor, “The preregistration revolution,” Proc. Natl.
Acad. Sci. USA, vol. 115, no. 11, pp. 2600–2606, 2018.
[20] K. F. Schulz and D. A. Grimes, “Blinding in randomised trials: hiding who got what,” Lancet, vol. 359,
no. 9307, pp. 696–700, 2002.
2013.
[2] Requirements for Electrical Installations. IET Wiring Regulations, BS 7671:2018+A2:2022, Institution of
Engineering and Technology and British Standards Institution, 2022.
[3] D. M. Pozar, Microwave Engineering, 4th ed. Hoboken, NJ, USA: Wiley, 2012.
[4] C. Furse, Y. C. Chung, C. Lo, and P. Pendayala, “A critical comparison of reflectometry methods for location
of wiring faults,” Smart Struct. Syst., vol. 2, no. 1, pp. 25–46, 2006.
[5] P. Smith, C. Furse, and J. Gunther, “Analysis of spread spectrum time domain reflectometry for wire fault
location,” IEEE Sensors J., vol. 5, no. 6, pp. 1469–1478, Dec. 2005.
[6] M. Zimmermann and K. Dostert, “A multipath model for the powerline channel,” IEEE Trans. Commun.,
vol. 50, no. 4, pp. 553–559, Apr. 2002.
[7] M. Sapir, “Apparatus for the detection and early warning of electrical arcing fault,” U.S. Patent 6 667 691 B2,
Dec. 23, 2003.
[8] J. Eriksen et al., “Electrical receptacles, assemblies thereof, and end of life functionality,” U.S. Patent Appl.
2024/0332946 A1, Oct. 3, 2024.
[9] R. E. Teggatz et al., “Electrical interconnect status monitoring system,” U.S. Patent 9 599 660 B2, Mar. 21,
2017.
[10] A. G. Sappok et al., “Radio frequency process sensing, control, and diagnostics network and system,” U.S.
Patent 10 799 826 B2, Oct. 13, 2020.
[11] L. Liao, Z. Liu, J. Du, and L. Hai, “A fault diagnosis method for pole-mounted circuit breakers based on
multi-information fusion,” CN Patent 121389025 B, Apr. 10, 2026 (assignee: Nanjing Ludian Intelligent
Technology Co., Ltd.).
[12] B. Maxson and W. Miller, “Ingress noise localization in a cable network,” U.S. Patent 8 724 681 B2, May 13,
2014.
[13] C. K. Chow, “On optimum recognition error and reject tradeoff,” IEEE Trans. Inf. Theory, vol. IT-16, no. 1,
pp. 41–46, Jan. 1970.
[14] Y. Geifman and R. El-Yaniv, “Selective classification for deep neural networks,” in Proc. Adv. Neural Inf.
Process. Syst. 30 (NIPS), 2017, pp. 4878–4887.
[15] JCGM, Evaluation of Measurement Data—Guide to the Expression of Uncertainty in Measurement, JCGM
100:2008, 2008.
[16] C. J. Clopper and E. S. Pearson, “The use of confidence or fiducial limits illustrated in the case of the
binomial,” Biometrika, vol. 26, no. 4, pp. 404–413, 1934.
[17] H. B. Mann and D. R. Whitney, “On a test of whether one of two random variables is stochastically larger
than the other,” Ann. Math. Statist., vol. 18, no. 1, pp. 50–60, 1947.
[18] J. Cohen, Statistical Power Analysis for the Behavioral Sciences, 2nd ed. Hillsdale, NJ, USA: Lawrence
Erlbaum, 1988.
[19] B. A. Nosek, C. R. Ebersole, A. C. DeHaven, and D. T. Mellor, “The preregistration revolution,” Proc. Natl.
Acad. Sci. USA, vol. 115, no. 11, pp. 2600–2606, 2018.
[20] K. F. Schulz and D. A. Grimes, “Blinding in randomised trials: hiding who got what,” Lancet, vol. 359,
no. 9307, pp. 696–700, 2002.